# Uconsole CM4 Overclock **URL:** \ **Category:** uConsole\ **Created:** [March 8, 2025, 9:28pm UTC](https://forum.clockworkpi.com/t/uconsole-cm4-overclock/15974 "2025-03-08T21:28:41Z")\ **Posts on this page:** 1\ **Page:** 1
**Author:** ![Caljank](https://yyz1.discourse-cdn.com/flex029/user_avatar/forum.clockworkpi.com/caljank/32/9263_2.png) [@Caljank](https://forum.clockworkpi.com/u/Caljank)\ **Post date:** [March 8, 2025, 9:28pm UTC](https://forum.clockworkpi.com/t/uconsole-cm4-overclock/15974/1 "2025-03-08T21:28:41Z")
I see this often enough that it seems prudent that it should have a post of its own. I see people asking about overclocking, I’ll post here what I’ve overclocked my CM4 to and I hope, if any of you have been more daring. You will share your observations and outcomes here. If you have a uconsole I suggest setting up your processor temp applet on the task bar. (right click the task bar, click to add. and put it where it suits you) With these settings I have not had temps above 53c (My general usage has it sitting at about 47c in a 72f room). But, I will admit that I use my phone for most streaming uses, my uconsole handles my web browsing and GBC emulation needs. This being said I have watched youtube a few times with this overclock and have been very pleased with the results. My Overclocking is admittedly middle of the road. But as I said I as of yet have not needed to push my hard. Perhaps if you intend to push your device farther. see what @thoughtfix has done for cooling on his uconsole with a cm5 here: [fixed CM5 Overheating problem](https://forum.clockworkpi.com/t/fixed-my-cm5-overheating-problem-with-a-riser-and-a-thin-thermal-pad/15872) > [@Uconsole cm4 lite with rpi emmc cm4](https://forum.clockworkpi.com/t/uconsole-cm4-lite-with-rpi-emmc-cm4/15251/15): > > Sudo nano /boot/firmware/config.txt > > [pi4] > max\_framebuffers=2 > arm\_freq=1800 > gpu\_freq=750 > over\_voltage=5 > [all] > gpu\_mem=256