Is there a way to reset the PicoCalc to the boot menu?

[BlairLeduc]

I did this, which is different (I’m not saying better!) from @pelrun’s approach:

Adding a SWD interface to the GPIO port

I develop in C on the PicoCalc which means I need to have a Debug Probe to connect to the SWD interface on the Pico. I was running a cable from the Pico out through the battery compartment. I noticed on the I/O ports on the side of the PicoCalc that there were two pins that I would never use: USB_DP and USB_DM which are connected to the USB C port if switch 2 was activated otherwise they are disconnected. These two pins are next to the GND pin. I cut the pins on the connector (completely rever…

Others have fed the SWD cable out through the battery compartment, which I did originally.