Display broken or firmware issue?

[white-round-square]

@EasyMeasurements_YH

After replacing it with pico2w and installing micropyhton, nothing is displayed on the display.

probably you broke the display

write email to help@clockworkpi.com and they will send you replacement

Before Replacing the Pico - READ THIS TO AVOID CRACKED SCREEN!

Before you replace the Pico in your PicoCalc, disconnect the FPC ribbon cable from the screen and remove the mainboard from the case. This was specified in another thread, but it can’t be stressed enough. Plugging a board into the Pico’s socket puts stress on the mainboard which then flexes enough to crack the screen. Another tip is to double check the alignment of the screen before screwing on the case back. If the screen doesn’t sit squarely in the opening, fastening the case back could cause …

Damaged Ribbon Cable for display

Afternoon all, So I was swapping my pico boards and seemed to of damaged the ribbon cable for my display. Yesterday I was getting a corrupted but functional screen. I did reseat the cable and the image stayed the same. I tried booting today and I’m not getting an video today. I looked on the shop and don’t see any replacement display options. Is there a compatible display I can look for?

My screen doesnt work, seems damaged(刚组装完，屏幕可点亮，不能正常显示)

i just got the picocalc and after i assembled it, i turn on the power on button, and the screen light on, but i cant read what it displayed, i can see 2 small crack in the corner of the screen. may need a replacement of the screen. 刚组装完，发现屏幕不能正常显示，重新安装屏幕排线也不行，发现屏幕内屏角落有两条裂纹，怀疑屏幕坏了，需要更换，求助！